Outback-power-systems FLEXware 1000 Users Guide Bedienungsanleitung PDF herunterladen (Seite 10)

Figure 5: Four FXs installed on FW-MPs

Note: The hanging straps are now removed.

Plastic bushing,

DC side

Figure 11: DCA bushing

Note: The DCA will be held rmly in place when the DCC (FX cover) is secured at the end of

the installation.

To install an ACA:

• Follow the separate ACA instructions for mounting to the FX.

• Line the ACA up with the conduit hole in the AC Chassis.

• When aligned, move the AC chassis snug against the ACAs after the ACA installations.

• Press a 1” plastic bushing from inside the AC chassis out to the ACA through each previously

removed knockout, sliding the AC chassis against the ACAs until snug.

• With all the ACA’s aligned with the AC chassis and the bushings installed, tighten the AC chassis

screws against the FW-MP.

With both the AC chassis and DC chassis installed, the breaker brackets, AC din rail(s), and

optional AC and DC breakers can be installed. Please see the individual Input/Output/Bypass

Breaker (IOB) kit for instructions.

1000 Manual.indd, Spread 10 of 12 - Pages (10, 15) 11/22/06 11:07 AM

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Keine Kommentare

Outback-power-systems FLEXware 1000 Users Guide Bedienungsanleitung Seite 10