Outback-power-systems FLEXnet DC Users Guide Bedienungsanleitung PDF herunterladen (Seite 9)

• Insert the FLEXNet DC inside the DC

breaker box and through the back side

of the breaker bracket; secure with two

#6-32 X 3/8 panhead machine screws

(included) torqued at 5 to 8 inch-pounds

• Connect all wires to the ten-pin wiring

connector. Do not leave any loose wires!

• Connect each twisted pair to a shunt.

Example:

• Battery side (green wire in

twisted pair) connects to the

battery negative side of the

shunt

• Device side (white wire in

twisted pair) connects to the

source/load (negative) side of

the shunt

NOTE: Color of wiring jacket

can vary

NOTE: The FLEXNet DC shunts must be connected in the negative (low) side of whatever they monitor.

Otherwise, the unit can be damaged.

Battery Negative

Source/Load Negative

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 33 34

Keine Kommentare

Outback-power-systems FLEXnet DC Users Guide Bedienungsanleitung Seite 9