Outback Power Systems FLEXware 500 Bedienungsanleitung

500User’s GuideIncludes Mounting, Installation, and Product Registration

After the FXs are installed, mount the AC chassis and the DC chassis in either order.Note: It is easier to remove the appropriate side knockouts from

Installation of the AC Chassis and DC Chassis To install the chassis:• Hold each chassis up to its respective mounting holes on the FW-MP. • Place o

Clear plastic AC coverAC Conduit PlateFigure 9: FX Series Inverter/ChargerDC Wiring Cover (DCC)Figure 8: AC and DC chassis mountedWith each chassis l

• Line up either the ACA or DCA on its respective side of the FX, starting at the top.• To attach a DCA, line up its two screw holes with the upper

Plastic bushing, DC sideFigure 11: DCA bushingNote: The DCA will be held rmly in place when the DCC (FX cover) is secured at the end of the installat

Figure 12: ACAs installedWith both the AC Chassis and DC Chassis installed, the breaker brackets, AC din rail(s), and optional AC and DC breakers ca

MX60 InstallationA FLEXware 500 System will normally have up to two MX Charge Controllers installed on the FW500-DC. The chassis accommodates both sid

The MX Charge Controller attaches to the chassis using three #10 X 3/8” sheet metal screws included in the hardware kit. Two are inserted from inside

Installing an OutBack HUBAn OutBack HUB allows the FX Series Inverter/Chargers, MX60 Charge Controllers, and MATE to communicate with each other. It a

Figure 15: Wiring Diagram17

OutBack Power Systems FLEXware is a system of modular aluminum mounting hardware and installation components designed for convenient system installati

Product RegistrationPlease take a moment to register and provide us with some important information. Send to: OutBack Power Systems, 19009 62nd Avenu

European Sales OfficeBarcelona, España(+34) 600-843-84519009 62nd Avenue NEArlington, WA USA(+1) 360-435-6030www.outbackpower.com900-0061-1

Requirements and WarningsThe OutBack FLEXware 500 enclosures (FW500-AC and FW500-DC) are listed by ETL as indoor enclosures to UL standard UL 508A Ind

Welcome to OutBack Power Systems’ FLEXwareFLEXware is a convenient all-aluminum power system oering simpler, code-compliant installation of OutBack p

HUBMX60sFigure 1: Complete FLEXware 500 System installed (vertical installation is acceptable when mounting space is limited)Note: Although FLEXware

Front ViewSide ViewFigure 2Knockouts and Dimensions11.4018.2712.063

A complete FLEXware 500 System consists of the following in addition to the FW500-AC and FW500-DC:• FLEXware Mounting Plate (FW-MP)• two FX Series

Installation Tips• Never use less than the minimum recommended number and type of fasteners when installing the FLEXware Mounting Plates. • Each

Figure 4: First FX installedWith the Mounting Plate and the hanging screws (for the FX Inverter/Chargers) inserted, install the FXs.• Start with the